Schluter KERDI-LINE-D-G3 Stainless Steel V4A Frameless Channel Cover For KERDI-LINE-G3

Schlüter-KERDI-LINE-D-G3 is a frameless channel cover to match Schlüter-KERDILINE-G3 channel bodies. The covering support features a fleece fabric for bonding with the tile adhesive and is universally suitable for all covering thicknesses.

Note: The length of the selected covering support must match the channel length.

Mounting the Schlüter-KERDI-LINE-D-G3 frameless covering support:
1. For wall installation, adhere the cover strip facing the wall, as shown, after removing the protective foil.
2. Then place the spacers in the channel body.
3. Install the covering of the shower area up to the channel body. Remove any excess thin-bed mortar completely and seal any open areas in the adhesive layer (see note).
4.
- In wall installation, the width (B) of the covering corresponds to the clearance from the wall to the inside edge of the spacer less 1 mm.
- For intermediate installation, the width of the covering corresponds to the inside width of the spacer (= 50 mm).
- At the exposed edges, the cover can either be adapted to the joint width of the entire covering or installed as a perimeter drainage.
5. Remove the spacers once the covering has cured and apply thin-bed mortar to the covering support.
6. Then adhere the covering with thin-bed mortar and align it. Leave the area of the covering support open when installing the cement grout.

Note: Remove any excess thin-bed mortar completely and seal any open areas in the adhesive layer.

Note: The use of acetic-crosslinking silicone is not permissible on channels, frames and grates.